Armory Craft P365 Slightly Curved Trigger, Black

Industry First! SIG Sauer P365 'SLIGHTLY CURVED' Trigger

Specification

Compatible with ALL P365 models: P365 P365 XL P365 SAS P365X

A direct replacement for your stock trigger for a smoother, more consistent pull.

• One-piece design
• CNC milled from solid bar-stock 4140 pre-hardened steel
• Nitride finish
• Made in the USA

Factory P365 curved and flat triggers are MIM parts. Our design follows the attractive skeletonized look of our P-series triggers, which were the first adjustable flat P-series triggers on the market.

• Our design promotes better trigger discipline - i.e. more accuracy, especially during rapid fire.
• Optimized *width*. Tighter & less ‘side-to-side’ wiggle vs. stock trigger.
• MADE IN USA
• CNC machined (NOT a MIM part)
• Actual trigger pull and reset remain the same while the perceived trigger pull weight is reduced by approximately 0.75 lbs.
• Manufacturing facility certified to ISO 9001/AS9100, and in accordance with the requirements of AS9104A.
• Our manufacturing facility is also manufacturing products for Boeing, US Coast Guard, Lockheed, Honeywell and other major US companies.

IMPORTANT:

Armory Craft P365 triggers are intended for installation by a qualified gunsmith or licensed armorer. While Armory Craft triggers are considered 'drop-in' and will fit without any issues in a vast majority of firearms, due to small manufacturing tolerances present in all mass-produced firearms, in some cases (5% or less) fitting will be required by a qualified gunsmith or armorer. Therefore, Armory Craft is not able to guarantee perfect fit and functionality in every firearm unless the part is properly fitted. Thank you for your understanding.